Hammant & Morgan Clipper Facelift. Replacement Faceplate (Fascia)

If your H & M Clipper is looking old and depressed, a new fascia may be what you are needing.
Printed on metalic media and laminated so you can wipe clean the surface.

You will need your sharpest knife to remove the cutouts 
( You can use your old fascia as a template).

Replacement Instructions:
1 Remove speed knobs - gently but firmly grasp them, and pull off.
(There are no screws involved).
2 Remove the screw above each of the speed knob spindles.
(These retain the facia)
3 Remove the two screws retaining the feet, and center retaining screw which enables the botton trim strip to be removed.
You can then slide the old facia out.
Reverse these instructions when you are ready to insert your new facia.
You can use double sided tape if required.